CEN

The new CEN range is specifically designed to meet the application requirements of wineries by offering precise control of refrigerated water temperature while operating over long time periods with varying load demands. The range includes 14 models with cooling capacities from 10 to 96 kW. It is designed for outdoor installation, with specific standard components especially indicated at low temperatures.:

• Compressor hermetic scroll type
• Micro-channel aluminium condenser with standard protective polyester powder coating for CEN 010÷038.
• Condenser manufactured of plated copper tubes with aluminium fins for CEN 046÷096.
• Stainlesteel brazed plate heat exchanger.
• Axial fans
• Centrifugal pump P2 type
• Thermostatic expansion valve sized to satisfy water setpoint 7°C / -8°C
• Ferrous pressure tank of the “hot” type
• Microprocessor controller (electronic thermostat for QBE002)
• RS485 port for modbus connections

All frame and cabinet cover material is made of galvanized steel that is then powder coated, making the CEN suitable for outdoor installation and for protection in harsh environments.

The compressor cabinet is separate from the fan’s section and is accessible on three sides to make control and maintenance easy. The hydraulic section is also easily accessible.

As an alternative to R410A, the CEN range is available with eco-friendly R454B refrigerant gas, with low environmental impact and GWP (global warming potential) of 466.

* Data referred to: Water Temperature IN/OUT @ Air Air °C
SEPR HT / EER data meet the requirements of the European Regulation (EU) 2016/2281 for eco-design.
The complete technical data can be found in the product brochure.

TheCEN chiller seriesis highly configurable

• Continuous fan(s) speed control – phase cut type (minimum ambient temperature -8.0°C)
• Continuous fan(s) speed control – electronic fan(s) (minimum ambient temperature -10.0°C)
• Electronic thermostatic valve
• Shut-off valves
• Anti-freeze heaters
• Condenser anticorrosion treatment (cataphoresis type)
• Compressor(s) acoustic shield(s)
• Single P3 Pump
• Non ferrous atmospheric water circuit (plastic water tank)
• Cold water tank configuration
• No tank configuration
• No pump configuration

• Additional atmospheric water tank kit (glycol charge)
• Double atmospheric water tank kit (glycol charge)
• Disconnector tank configuration with P2/P3 pump
• Mechanical water level
• switch P2/P3 configuration for glycol up to 50%
• Partial / Full heat recovery
• Electrical switchboard anti-condensation heater
• Remote Panel Kit
• Water connections kit (GAS)
• Rubber anti-vibration mountings kit
• Wheels kit