FCT VS
VARIABLE SPEED REFRIGERATION DRYERS WITH R513A REFRIGERANT
Flow rate: 1 260 ÷ 8 832 m3/h
The FCT VS range was created to meet the latest energy saving and low environmental impact market demands. This range combines the experience...
Share
The FCT VS range was created to meet the latest energy saving and low environmental impact market demands. This range combines the experience gained with environmentally friendly gases used in the FCT range and the inverter technology (Variable Speed) applied to the ACT VS; this brings the advantages of both ranges in a single solution. The low environmental impact R513A refrigerant gas combined with a variable speed operation is the height of technological evolution and maximises respect for the environment. By using inverters, it is possible to modulate the electrical power input by the scroll compressor and fans according to the thermal load required by the user.
Main advantages are:
- greater environmental friendliness;
- reduced running cost;
- optimised consumption and performance under all load conditions.
The graph compares the power consumption of the FCT VS dryer to the equivalent standard FCT model at different load conditions. The various operating modes of the FCT VS dryer which can be set directly from the controller display are represented on the right of the graph.
MAXIMUM WORKING CONDITIONS
- Ambient temperature: + 45°C
- Inlet air pressure: 14 barg
- Inlet air temperature: + 70°C
Data refer to the following nominal condition: ambient temperature + 25 °C; inlet air pressure 7 barg; inlet air temperature +35 °C.
- ALU DRY aluminium heat exchanger
- High-efficiency compressor
- Generously sized condenser unit
- Water pressure switch valve (water-cooled)
- DMC34 digital controller RS485 modbus
- Refrigerant compressor thermal or thermo-ammeter protection
- Automatic condensation pressure control
- High compressor temperature protection
- Refrigerant compressor phase sequence relay protection (3ph models)
- Refrigerant high- and low-pressure safety pressure switches
- Electronic expansion valve
- Electronic bypass valve
- Electronic level condensation drain
- Compressor crankcase heater (3ph models only)
- On request models with different Power Supply and different connections [Ph/V/Hz]
- Counter-flanges and EN 1092-1 gaskets included.
WC TBH
Water cooling. Tube bundle condenser
SERVICE UNIT
8.000 hours maintenance kit for BK type electronic drain
BY-PASS
By-pass group
Main features
The FCT VS range was created to meet the latest energy saving and low environmental impact market demands. This range combines the experience gained with environmentally friendly gases used in the FCT range and the inverter technology (Variable Speed) applied to the ACT VS; this brings the advantages of both ranges in a single solution. The low environmental impact R513A refrigerant gas combined with a variable speed operation is the height of technological evolution and maximises respect for the environment. By using inverters, it is possible to modulate the electrical power input by the scroll compressor and fans according to the thermal load required by the user.
Main advantages are:
- greater environmental friendliness;
- reduced running cost;
- optimised consumption and performance under all load conditions.
The graph compares the power consumption of the FCT VS dryer to the equivalent standard FCT model at different load conditions. The various operating modes of the FCT VS dryer which can be set directly from the controller display are represented on the right of the graph.
MAXIMUM WORKING CONDITIONS
- Ambient temperature: + 45°C
- Inlet air pressure: 14 barg
- Inlet air temperature: + 70°C
Technical Data
Data refer to the following nominal condition: ambient temperature + 25 °C; inlet air pressure 7 barg; inlet air temperature +35 °C.
Main Components
- ALU DRY aluminium heat exchanger
- High-efficiency compressor
- Generously sized condenser unit
- Water pressure switch valve (water-cooled)
- DMC34 digital controller RS485 modbus
- Refrigerant compressor thermal or thermo-ammeter protection
- Automatic condensation pressure control
- High compressor temperature protection
- Refrigerant compressor phase sequence relay protection (3ph models)
- Refrigerant high- and low-pressure safety pressure switches
- Electronic expansion valve
- Electronic bypass valve
- Electronic level condensation drain
- Compressor crankcase heater (3ph models only)
- On request models with different Power Supply and different connections [Ph/V/Hz]
- Counter-flanges and EN 1092-1 gaskets included.
Brochure
Options and Accessories
WC TBH
Water cooling. Tube bundle condenser
SERVICE UNIT
8.000 hours maintenance kit for BK type electronic drain
BY-PASS
By-pass group